Operation; Switching On/Off; Attaching/Removing Sanding Sheet - Parkside PHS 160 C4 Originalbetriebsanleitung

the power tool increases the risk of
electric shock.
Avoid overheating the sanded
•
object and the sander itself. Pos-
sible fire hazard.
The workpiece gets hot dur-
•
ing grinding. Do not touch the
machined area, allow it to cool
down. There is a risk of burning. Do
not use coolants or the like.
Always empty the dust con-
•
tainer before work breaks.
Sanding dust in the dust sack, micro
filter, paper sack (or in the filter sack or
extraction system filter) can self-ignite
under unfavourable conditions such
as flying sparks caused by grinding
metals. Particular hazards are caused
if the sanding dust is mixed with paint,
polyurethane residues or other chemi-
cal substances, or if the sanded object
is hot after long working periods.
• If the supply cord of this power
tool is damaged, it must be re-
placed by a specially prepared
cord available through the ser-
vice organization.
RESIDUAL RISKS
Even if properly operating and handling
this electric tool, some residual risks will
remain. Due to its construction and build,
this electric tool may present the following
hazards:
a) Lung damage, if suitable respiratory
protection is not worn;
b) Cuts
c) Ear damage if working without ear pro-
tection.
d) Eye damage if suitable eye protection
is not worn.
e) Damage to your health caused by
swinging your hands and arms when
operating the appliance for longer pe-
riods of time or if the unit is not held or
maintained properly.

Operation

Switching on/off

Make sure that the power supply
voltage matches the voltage rat-
ing indicated on the device's type
plate.
Connect the machine to the power
supply.
1. To switch on, flick the on/off switch
(1) to position
on.
2. To switch off, flick the on/off switch
(1) to position
off.
Attaching/removing sanding
sheet
The sanding plate (12) is fitted with Velcro
for rapid attachment of the sanding sheet
(15).
Attaching sanding sheet
1. Press the sanding sheet (15) evenly
onto the sanding plate (12). Ensure
that the holes in the sanding sheet (15)
are placed above the openings in the
sanding plate (12).
Removing sanding sheet
2. Simply pull the sanding sheet (15) off
the sanding plate (12).
„I". The tool will power
„0". The tool will power
G B
9