Use the hex key
[
31 ]
a counter-clockwise direction .
Remove the old sanding pad
Align the centre hole
pad with the spindle
Place the washer
38 ]
[
screw
.
[
37 ]
Use the hex key
31 ]
[
clockwise direction .
Replacing the carbon brushes
(Fig . S)
m
WARNING!
Always replace both carbon brushes at the
u
same time .
Do not use accessories not recommended
u
by Parkside . Using incompatible carbon
brushes may result in electric shock,
personal injury or property damage .
Use the slotted screwdriver
carbon brush holder cap
clockwise direction .
Remove the carbon brush holder cap
spring of the carbon brush comes out .
Remove the carbon brush .
Insert the spare carbon brush
carbon brush holder .
Gently compress the spring of the carbon
brush
using the carbon brush holder
34 ]
[
cap
until the spring is completely pushed
6 ]
[
inside .
Use the slotted screwdriver
carbon brush holder cap
direction .
Repeat for the second carbon brush
the other side .
22 GB/IE/NI
to loosen the screw
37 ]
[
.
[
2 ]
of the new sanding
39 ]
[
.
[
40 ]
on the thread of the
to fasten the screw
[
37 ]
to loosen the
[
32 ]
in a counter-
[
6 ]
. The
6 ]
[
into the
[
34 ]
to fasten the
[
32 ]
in clockwise
[
6 ]
on
34 ]
[
Repair
in
This product does not contain any parts that can
be repaired by the user . Contact an authorised
service centre or a similarly qualified person to
have it checked and repaired .
m
WARNING! RISK OF INJURY!
in
If the power cord is damaged, it must be
u
replaced by the manufacturer, its service
agent or similarly qualified persons in order
to avoid a hazard .
Storage
Switch off the product and disconnect it from
the mains . Let the product cool down .
Clean the product as described before .
Store the product and its accessories in a
dark, dry, frost-free, well-ventilated place .
Always store the product in a place that is
inaccessible to children . The ideal long term
storage (longer than 3 months) temperature
is between +10 and +30 °C with a relative
humidity of max . 60 % .
Transportation
Switch off the product and disconnect it from
the mains . Let the product cool down .
Protect the product from any heavy impact
or strong vibrations which may occur during
transportation in vehicles .
Secure the product to prevent it from slipping
or falling over .