After Use; Cleaning And Care; Cleaning; Maintenance - Parkside PWDS 920 B2 Bedienungs- Und Sicherheitshinweise

Move the sanding paper
across the working surface . Do not keep the
sanding paper on one spot for too long . This
may lead to irregular results .
Before switching off: Lift the product from the
working surface .
Before putting the product aside: Wait until
the sanding pad
2 ] [
Sanding walls
(Fig . P)
Always hold the product with 2 hands .
Sanding ceilings
(Fig . Q)
You can turn the product by 180° to reach
the surface more easily and comfortably .
˜ After use
Switch off the product and disconnect it from
the mains . Let the product cool down .
Check, clean and store the product
(see "Cleaning and care") .
˜ Cleaning and care
m
WARNING!
Always switch the product off,
disconnect it from the mains and let the
product cool down before performing
inspection, maintenance and cleaning
work!
continuously
[ 33 ]
stops rotating .
˜ Cleaning
Never allow fluids to get into the product .
The product must always be kept clean, dry
and free from oil or grease . Remove dust from
it after each use and before storage .
Regular and proper cleaning will help ensure
safe use and prolong the life of the product .
Clean the product with a dry cloth . Use a soft
brush for areas that are hard to reach .
NOTE
Do not use chemical, alkaline, abrasive or
u
other aggressive detergents or disinfectants
to clean this product . These detergents
and disinfectants might be harmful to the
product's surfaces .
˜ Maintenance
Before and after each use, check the product
and accessories (e . g . sanding paper) for
wear and damage . If required, exchange
them for new ones as described in this
instruction manual . Observe the technical
requirements (see "Technical data") .
Replacing the sanding pad
(Fig . R)
m
WARNING!
Do not use accessories not recommended
u
by Parkside . Using an incompatible sanding
pad may result in personal injury or
property damage .
Hold the sanding pad firmly .
2 ] [
GB/IE/NI 21