Assembling Instructions; Attaching/Removing Sanding Sheet; Mounting Sanding Fi Nger - Parkside PMS 160 A1 Originalbetriebsanleitung

GB IE NI
magnetic fi eld which, under certain
circumstances, may impair the
functionality of active or passive
medical implants. To reduce the risk
of serious or lethal injuries, we rec-
ommend that persons with medical
implants consult their doctor and
the manufacturer of their medical
implant before operating the ma-
chine.

Assembling instructions

Pull the mains plug before any ad-
justments, maintenance or repair.
Danger of electric shock.
Attaching/removing sanding
sheet
Clean the sanding disc before you
attach a sanding sheet.
Use only appropriate sanding sheet
sizes. Sanding sheets, which ex-
tend beyond the sanding disc, can
cause injuries and can cause the
sanding sheets to block or tear.
The sanding plate (6) is fi tted with Velcro
for rapid attachment of the sanding sheet
(11).
The sanding sheets (11) comprise 2 parts
and can be individually replaced depend-
ing on wear.
To achieve optimal sanding results, only
use sanding sheets with the right grain
size.
Attaching sanding sheet:
1. Press both parts of the sanding
sheet (11) evenly onto the sand-
ing plate (6). Please ensure that
the sanding sheets lie fl ush and
10
CY
the holes are placed directly
above the extraction openings
(14) of the sanding plate (6).
Removing sanding sheet:
2. Pull the sanding sheet (11) from
the sanding plate (6).
Only perform sanding once both
sanding sheets are mounted.
Mounting sanding fi nger
You can replace the pre-mounted sanding
plate (6) with the sanding fi nger (12) pro-
vided in the scope of delivery.
Unmounting sanding plate:
1. Open the clamping lever (15)
and turn it in the direction of the
sanding sheet until it reaches the
stop.
2. Remove the front section of the
sanding plate (6).
Inserting sanding fi nger:
3. Insert the sanding fi nger (12)
from above against the back sec-
tion of the sanding plate (6) and
push it fi rmly into place.
4. To lock, turn the clamping lever
(15) into its original position.
Attaching sanding sheet for
sanding fi nger:
5. Press the sanding plate for the
sanding fi nger (13) evenly onto
the sanding fi nger (12).
6. Place a sanding sheet onto the
back section of the sanding plate
(6). This will prevents soiling of
the Velcro.