Attaching/Removing Sanding Sheet; Mounting Sanding Finger; Connecting/Removing/Emptying The Dust Collection Box - Parkside PMS 160 A1 Originalbetriebsanleitung

Attaching/removing
sanding sheet
Clean the sanding disc before you
attach a sanding sheet.
Use only appropriate sanding sheet
sizes. Sanding sheets, which ex-
tend beyond the sanding disc, can
cause injuries and can cause the
sanding sheets to block or tear.
The sanding plate (6) is fitted with Velcro
for rapid attachment of the sanding sheet
(11).
The sanding sheets (11) comprise 2 parts
and can be individually replaced depend-
ing on wear.
To achieve optimal sanding results, only
use sanding sheets with the right grain
size.
Attaching sanding sheet:
1. Press both parts of the sanding sheet
(11) evenly onto the sanding plate (6).
Please ensure that the sanding sheets
lie flush and the holes are placed di-
rectly above the extraction openings
(14) of the sanding plate (6).
Removing sanding sheet:
2. Pull the sanding sheet (11) from the
sanding plate (6).
Only perform sanding once both
sanding sheets are mounted.

Mounting sanding finger

You can replace the pre-mounted sanding
plate (6) with the sanding finger (12) pro-
vided in the scope of delivery.
Unmounting sanding plate:
1. Open the clamping lever (15)
and turn it in the direction of the
sanding sheet until it reaches the
stop.
2. Remove the front section of the
sanding plate (6).
Inserting sanding finger:
3. Insert the sanding finger (12)
from above against the back sec-
tion of the sanding plate (6) and
push it firmly into place.
4. To lock, turn the clamping lever
(15) into its original position.
Attaching sanding sheet for
sanding finger:
5. Press the sanding plate for the
sanding finger (13) evenly onto
the sanding finger (12).
6. Place a sanding sheet onto the
back section of the sanding plate
(6). This will prevents soiling of
the Velcro.
Connecting/removing/
emptying the dust col-
lection box
Connecting the dust collection box:
1. Before connecting, ensure that the dust
collection box (8) is firmly closed.
2. Slide the dust collection box (8) all the
way onto the dust extraction connector
(4). Pay attention to the guide rollers
(16) on the dust extraction connector
(4).
3. Turn the dust collection box (8) clock-
wise to fasten.
Removing the dust collection box:
4. Turn the dust collection box (8) coun-
ter-clockwise to undo.
5. Remove the dust collection box (8).
GB MT
55