Adjusting The Speed; Removing And Attaching The Detachable Front Guard Cover; Switching The Led Working Lamp On And Off; Rotating And Tilting The Motor Housing - Parkside PWDS 920 B2 Bedienungs- Und Sicherheitshinweise

˜ Adjusting the speed
(Fig . K)
NOTES
Adjust the speed, before you apply the
u
product to the surface .
Use a low speed for rough sanding . Use a
u
high speed for smooth finishing .
Increasing speed: Press the + button
Reducing speed: Press the – button
NOTE
After you switch off the product, the
u
sanding pad keeps on rotating for a
[ 2 ]
short while . Wait until the sanding pad
stops rotating, before you put the product
aside .
˜ Removing and attaching the
detachable front guard cover
(Fig . L)
NOTE
You can remove the detachable front guard
u
cover , if you want to apply the product
[ 3 ]
closer to the wall/ceiling .
Removing: Slightly press down the front
guard cover lock
4 ] [
Pull the detachable front guard cover
the sanding guard
Attaching: Reattach the detachable front
guard cover to the sanding guard
3 ] [
The front guard cover lock
place .
20 GB/IE/NI
[ 17 ]
[ 16 ]
.
off
[ 3 ]
.
[ 1 ]
.
1 ] [
must click into
[ 4 ]
˜ Switching the LED working
lamp on and off
(Fig . M)
Switching on: Press the LED working lamp
down into the I position .
switch
[ 12 ]
Switching off: Press the LED working lamp
down into the O position .
switch
[ 12 ]
˜ Rotating and tilting the motor
.
housing
.
(Fig . N, O)
NOTE
By rotating and tilting the motor housing
u
you can maximise the accessibility to the
working surface . This allows the sanding
pad to follow the contours of the
[ 2 ]
working surface .
You can rotate the motor housing
left and right by up to 30° .
You can tilt the motor housing
by up to 30° .
You can tilt the motor housing
by up to 90° .
˜ Working instructions
Select and attach a sanding paper
Switch on the product and adjust the speed .
Wait until the product has reached the set
speed .
Hold the sanding pad
working surface . Touch the working surface
with the brush edge
Apply some pressure so that the sanding
paper touches the working surface .
[ 33 ]
[ 5 ]
to the
[ 5 ]
to the front
5 ] [
to the back
5 ] [
.
33 ] [
parallel to the
[ 2 ]
.
[ 7 ]