Attaching/Removing Sanding Sheet - Parkside PMFS 200 B2 Originalbetriebsanleitung

Installing the eccentric
grinder disc:
5. Place the desired eccentric
grinder disc (17) on the mount-
ing plate (23).
6. Fasten the sanding disc with the
4 Phillips screws (22).
7. Make sure that the sanding disc
is firmly in place.
Installing the orbital sand-
er disc and hand sander
disc:
5. Insert the 4 rubber pins (27) with
the latching nose (27a) into the
4 recesses in the sanding disc
(18/
6. Place the desired sanding disc
(18/
plate (23).
The rubber pins (27) fit into the
recesses of the device. Only one
position is possible.
7. Fasten the sanding disc with the
4 Phillips screws (22).
8. Make sure that the sanding disc
is firmly in place.
Attaching/removing sanding
sheet
Clean the sanding disc before you
attach a sanding sheet.
When using sanding sheets without
ventilation holes, dust extraction is
not possible.
Use only appropriate sanding sheet
sizes. Sanding sheets, which ex-
tend beyond the sanding disc, can
cause injuries and can cause the
sanding sheets to block or tear.
12).
12) on the mounting
Sanding sheet with Velcro
The sanding discs are fitted with Velcro back-
ing for quick mounting of sanding sheets.
Attaching sanding sheet:
1. Press the desired sanding sheet
(19/
the sanding disc (12/
18). Ensure that the ventilation
holes in the sanding sheet are
placed directly above the extrac-
tion openings in the sanding disc.
Removing sanding sheet:
2. Simply pull the sanding sheet
(19/
ing disc (12/
Sanding sheet without Velcro
The orbital sander disc (12) is equipped
with terminal strips (13) for clamping sand-
ing sheets without Velcro (sanding sheets
not included).
Clamping sanding sheet:
1. Open the two clamping levers
(14) on the orbital sander disc
(12).
2. Slide one end of the sanding
sheet under the terminal strip
(13).
3. Clamp the sanding sheet by lock-
ing the clamping lever (14).
4. Pull the sanding sheet tightly
over the orbital sander disc (12).
Clamp the other end of the sand-
ing sheet.
Removing sanding sheet:
5. Open the two clamping levers
(14) and pull out the sanding
sheet.
20/ 21) evenly onto
17/
20/ 21) off the sand-
17/ 18).
G B
1 1