Locking: Rotate the lock collar
clockwise .
Unlocking: Rotate the lock collar
clockwise .
NOTE
The hose stand
[
27 ]
u
hose
from excessive bending, when you
[
28 ]
place the product on a floor in an upright
position .
Changing the hose adaptor
(Fig . H, I)
NOTES
The hose adaptor
u
diameter of 47 mm is pre-installed on the
vacuum hose
. This adaptor can be
[
28 ]
directly connected to an industrial vacuum
cleaner without using its extraction hose .
Connecting the extraction hose of your
u
vacuum cleaner to the product: Attach the
hose adaptor
[
30 ]
39 mm to the vacuum hose
Removing: Use the slotted screwdriver
to press down one of the locking clips on the
dual clip lock ring
36 ]
[
When the locking clip is fully pressed down,
pull out the dual clip lock ring from the hose
adaptor
. The sealing ring
[
29 ]
completely separated .
18 GB/IE/NI
counter-
25 ]
[
25 ]
[
protects the vacuum
with an outer
[
29 ]
with an outer diameter of
.
28 ]
[
32 ]
[
.
must be
35 ]
[
Attaching: Insert the sealing ring
the hose adaptor
30 ]
[
Align the holes on the hose adaptor with the
locking clips on the dual clip lock ring
Press down one of the locking clips by hand .
Insert the dual clip lock ring into the hose
adaptor . Rotate the hose adaptor by 180°
and repeat the same steps on the opposite
side . Both locking clips must snap into the
holes on the hose adaptor .
Selecting sanding paper
If you need to purchase additional sanding
paper, select sanding paper with following
characteristics:
–
Diameter (Ø): 225 mm
–
Hook-and-loop fastener on the back
–
Pre-punched holes matching the position of
the holes on the sanding pad
–
Made of aluminium oxide, silicon carbide
or other synthetic abrasives
The grit size is printed on the back of the
sanding paper . The smaller the number, the
coarser the grain .
Rough sanding: Use a sanding paper with
a small number .
Smooth finishing: Use a sanding paper
with a large number .
In order to obtain best results, start with a
coarse grain first . Complete the process with
the finest grain possible .
into
35 ]
[
.
.
36 ]
[
2 ]
[