Qualification Of Personnel; Target Group - Optimum OPTigrind GZ 20C Betriebsanleitung

1.4 Possible dangers caused by the grinding machine
The grinding machine is state-of-the-art. Nevertheless, there is a residual risk as the grinding machine opera-
tes with

high speeds,

rotating parts,

grinding wheels (emission of sparks),

cleaning brushes,

with electrical voltages and currents.
We have used construction resources and safety techniques to minimize the health risk to persons resulting
from these hazards.
If the grinding machine is used and maintained by the staff who are not duly qualified, there may be a risk
resulting from incorrect or unsuitable maintenance of the grinding machine.
INFORMATION
Everyone involved in the assembly, commissioning, operation and maintenance must

be duly qualified,

strictly follow these operating instructions.
Always disconnect the grinding machine machine from the electrical power supply when performing cleaning
or maintenance works.
WARNING!
The grinding machine may only be used with the safety devices activated.
Disconnect the grinding machine immediately whenever you detect a failure in the safety devices or
when they are not mounted!
All additional devices installed by the operator have to be equipped with the prescribed safety
devices.
This is your responsibility being the operating company!

Safety devices on page 26
1.5

Qualification of personnel

1.5.1

Target group

This manual is addressed to

the operating companies,

the users,

the staff for maintenance works.
Therefore, the warning notes refer to both operation and maintenance of the grinding machine.
Always disconnect the grinding machine plug from the mains. This will prevent it from being used by
unauthorized staff.
The qualifications of the staff for the different tasks are mentioned below:
Operator
The operator is instructed by the operating company about the assigned tasks and possible risks in case of
improper behaviour. Any tasks which need to be performed beyond the operation in the standard mode must
only be performed by the operator if it is indicated in these instructions and if the operating company expres-
sively commissioned the operator.
Version 1.0.2 - 2021-5-5 Translation of original instruction
GZ grinding machines EN
25