Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
grinding wheel (emission of sparks),
a sanding belt,
electrical voltage and currents.
We have used design and safety engineering to minimize the health risk to personnel resulting
from these hazards.
If the grinding machine is used and maintained by personnel who are not duly qualified, there
may be a risk resulting from its incorrect or unsuitable maintenance.
INFORMATION
Everyone involved in the assembly, commissioning, operation and maintenance must
be duly qualified,
and strictly follow these operating instructions.
Always disconnect the grinding machine from the electrical power supply before performing
cleaning or maintenance tasks.
CAUTION!
The grinding machine may only be operated with clamped support plate and clamped
rotation possibility of the belt grinding device. Operation with a dismantled counter
support for the workpiece or in the non-clamped state of setting options can lead to
dangerous conditions for the operator. Make sure that the gap between the support plate
of the workpiece on the belt grinder and the grinding wheel is as small as possible.
Disconnect the grinding machine immediately, whenever you detect a failure in the
safety devices or when they are not fitted!
All additional devices installed by the operator must be equipped with the stipulated
safety devices. This is your responsibility as the operator!
Safety devices on page 28
1.5
Personnel qualification
1.5.1
Target group
This manual is addressed to
the operating companies,
the operators,
the maintenance personnel.
Consequently, the warning notes refer both to the use of the grinding machine and to its main-
tenance.
Always disconnect the grinding machine from the electrical power supply. This will prevent it
from being used by unauthorized persons.
The qualifications of the personnel for the different tasks are mentioned below:
Operator
The operator has been instructed by the operating company regarding the assigned tasks and
possible risks in case of improper behaviour. Any tasks which need to be performed beyond the
operation in standard mode must only be performed by the operator, if so indicated in these
instructions and if the operator has been expressively commissioned by the operating com-
pany.
Qualified electrician
With professional training, knowledge and experience as well as knowledge of respective
standards and regulations, qualified electricians are able to perform work on the electrical sys-
tem and recognise and avoid any possible dangers.
Safety
Version 1.0.2 - 2021-03-10
Translation of original instruction
GU30S
EN
27
Werbung
Inhaltsverzeichnis
