Operator Responsibilities; Intended Operation; Checks - BWT AQA perla XL Einbau- Und Bedienungsanleitung

9

Operator responsibilities

You have purchased a product that is durable and
easy to service. However, certain duties must be
carried out. Flawless function requires:
● Operation as intended
● Regular checks and servicing
Check the quality and pressure conditions of the
inflow water regularly with your water supplier. If the
water quality changes, the settings may need to be
changed. Consult a specialist in this case.
To ensure the proper functioning and safety of
the product, regular inspections must be carried
out by the operator (every 2 months), and routine
maintenance (EN 806-5) must be performed by the
BWT after-sales service staff or a fitter authorised
by BWT to carry out maintenance (every 6 months).
Wearing parts must also be replaced after the
prescribed intervals in order to guarantee functio-
nality and fulfil the warranty conditions.
9.1

Intended operation

The intended operation of the product includes
start-up, operation, decommissioning and, if ne-
cessary, recommissioning. Intended operation of
the product and drinking water installation requires
regular checks, servicing and operation (water
flows through the product) in accordance with the
operating conditions for design and construction,
including simulated sampling (manual or automated
rinsing), as appropriate. If simulated sampling is not
possible, the product must be taken out of service.
9.2

Checks

(Carried out by the operator)
BWT recommends that the operator regularly carry
out the following checks and record the results:
● Water quality. Depending on the product, inflow
water values and set outlet water values may
need to be corrected.
● Water pressure. If the pressure conditions
change, the product settings may also have to
be changed.
● Operating condition of the product.
● Check whether messages have been issued.
● Watertightness.
EN
83
83