Safety Instructions; General Safety Instructions; Scope Of The Documentation; Personnel Qualifications - BWT AQA perla XL Einbau- Und Bedienungsanleitung

EN
1

Safety Instructions

1.1

General safety instructions

The product was manufactured according to all
recognised regulations and technical standards and
was in compliance with the relevant legal require-
ments when it was put into circulation.
Nevertheless, it can pose a risk of personal injury
or property damage if you do not observe this
chapter and the safety instructions throughout this
documentation.
● Read this documentation thoroughly and in full
before working with the product.
● Retain the documentation in such a way that it is
accessible to all users at all times.
● Always hand over the product to third parties to-
gether with the full documentation.
● Follow all of the instructions in relation to the
proper handling of the product.
● If you detect damage to the product or the mains
supply, stop its operation and notify a service
technician immediately.
● Use only accessories, spare parts and con-
sumable materials that have been approved by
BWT.
● Adhere to the environmental and operating con-
ditions specified in the "Technical data" chapter.
● Use your personal protective equipment. It en-
sures your safety and protects you from injury.
● Only perform tasks that are described in these
operating instructions or if you have been
trained to do so by BWT.
● Perform all tasks in compliance with all applica-
ble standards and provisions.
● Instruct the operator in the function and opera-
tion of the product.
● Instruct the operator in the maintenance of the
product.
● Instruct the operator in relation to potential dan-
gers that may arise while operating the product.
50
1.2

Scope of the documentation

This documentation applies exclusively to the
product the production number of which is listed
in chapter 12 "Technical Data".
This documentation is intended for operators,
installers without training from BWT, installers with
training from BWT (e.g. drinking water specialists),
and BWT service technicians.
This documentation contains important information
for fitting the product safely and properly, starting
up, operating, using, maintaining, and disassem-
bling the product, and for correcting simple faults
independently.
Read this documentation in full before working with
the product. Pay particular attention to the chapter
"Safety Instructions".
1.3 Personnel qualifications
The installation work described in these instructions
requires basic knowledge of mechanics, hydraulics
and electrical systems as well as knowledge of the
corresponding specialist terms.
To ensure that the device is installed safely, this work
must be performed only by a qualified specialist or
a trained person under the guidance of a qualified
specialist.
A qualified specialist is anyone who can assess
the work assigned to him or her, identify potential
risks, and take suitable safety measures thanks
to his or her specialist training, knowledge and
experience as well as his or her knowledge of the
applicable regulations. A qualified specialist must
comply with the applicable specialist regulations.
An instructed person is anyone who has been
instructed and, if necessary, trained by a qualified
specialist in the transferred tasks and the potential
risks presented by improper behaviour and who
has been educated about the necessary protective
equipment and measures.