General Safety Precautions; Obligations And Liability; Explanation Of Symbols And Warnings, Etc - HYDAC International ContaminationSensor CS 1000 Serie Betriebs- Und Wartungsanleitung

ContaminationSensor CS

1 General Safety Precautions

These operating instructions contain the key instructions for properly and safely operating the
CS.
1.1

Obligations and Liability

•
The basic prerequisite for the safe and proper handling and operation of the CS is
knowledge of the safety instructions and warnings.
•
These operating instructions in general, and the safety precautions in particular, are
to be adhered by all those who work with the CS.
•
Adherence is to be maintained to pertinent accident prevention regulations applicable
at the site where the product is used.
•
The safety precautions listed herein are limited solely to using the CS.
The CS has been designed and constructed in accordance with the current state of the art
and recognized safety regulations. Nevertheless, hazards may be posed to the life and limb
of the individual using the product or to third parties. Risk of damage may be posed to the
product or other equipment and property. The CS is to be used as follows:
•
solely for its designated use
•
only when in a safe, perfect condition
•
Any faults or malfunctions which might impair safety are to be properly repaired or
remedied immediately.
Our General Terms and Conditions apply. They are made available to the owner upon
concluding purchase of the product at the latest. Any and all warranty and liability claims for
personal injuries and damage to property shall be excluded in the event they are attributable
to one or more of the following causes:
•
improper use of the CS or use deviating from its designated use
•
improper assembly, installation, commissioning, operation and maintenance of the
CS
•
operating the CS when the system equipment or systems are defective
•
modifications to the product made by the user or purchaser
•
improper monitoring of product components subject to wear and tear
•
improperly performed repair work
1.2

Explanation of Symbols and Warnings, etc.

The following designations and symbols are used in this manual to designate hazards, etc.:
HYDAC Filtertechnik GmbH
BeWa CS1000 3247149-02j en.doc
All manuals and user guides at all-guides.com
en
General Safety Precautions
Page 77
2004-07-12