ContaminationSensor CS 1000
12.3
Power adaptor set-up
Check the set-up of the AC/DC adaptor according to following picture.
Check correct line plug. If not select the correct plug and change this.
Check output voltage at 12 Volt. If not, set to 12.
Check the arrows of the plug and socket as shown.
The "+" symbol must be connected to the inner contact of the plug.
If not, reverse the plug.
HYDAC Filtertechnik GmbH
BeWa CS1000 3247149-02j en.doc
All manuals and user guides at all-guides.com
en
Contamination Sensor Interface CSI
Page 116
2005-11-10