Herunterladen Inhalt Inhalt Diese Seite drucken

Final Adjustment Of Motor Endpoints; Adjusting The Upper Endpoint; Adjusting The Lower Endpoint - Renson Fixvent Mono AK/UT EVO Montageanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Fixvent
Mono AK/UT
®
en
9 • Final adjustment of motor endpoints
The motor endpoints (for operating a Fixvent Mono AK/UT
are partially pre-adjusted.
9.1 • Adjusting the upper endpoint
Renson has already adjusted the upper endpoint. During adjustment, the bottom bar is as near as
possible to the box.
9.2 • Adjusting the lower endpoint
The lower endpoint is set to the factory settings (approx. 400 mm from the bottom of the box). The
installer should adjust the lower endpoint (see the supplied manual on adjusting motors for vertical
screens).
ATTENTION : adjust the endpoint to a few mm short of the end of the side channel, so that the
fabric remains nice and tight.
Roll the screen fabric up and down a few times to ensure good operation.
Tip: in case the electricity works take place after the assembly of the screen, a temporary
power cable can be used to set the end points of the solar protection.
6 4
• Fixscreen
EVO
/ Fixscreen Mono AK
EVO
Mono AK
®
EVO
screen)
EVO

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Fixscreen mono ak evo

Inhaltsverzeichnis