BAE SA-OH-059-YI- ----
Photoelectric Sensors
6
Startup and operation
6.1
Startup
DANGER
Uncontrolled system movement
When starting up, if the sensor is part of a closed loop
system whose parameters have not yet been set, the
system may perform uncontrolled movements. This
could result in personal injury and equipment damage.
► Persons must keep away from the system's hazar-
dous zones.
► Startup must be performed only by trained technical
personnel.
► Observe the safety instructions of the equipment or
system manufacturer.
1. Check connections for tightness and correct polarity.
Replace damaged connections.
2. Turn on the system.
3. Check measured values and adjustable parameters
and realign and adjust the sensor, if necessary.
Check for the correct values, especially after
replacing the sensor or after repair by the manu-
facturer.
6.2
Operating notes
–
Regularly check function of the sensor and all associa-
ted components.
–
Take the sensor out of service whenever there is a
malfunction.
–
Secure the system against unauthorized use.
–
Check fasteners and retighten if needed.
6.3
Maintenance
The product is maintenance-free.
www.balluff.com
english
11