Input And Output Buffers - Balluff BIS C-60 2 Serie Handbuch

C60_2-028_823024_0401-e.p65
17
Input and Output
Buffers
Please note the
basic procedure on
16 and 30...34
and the examples
on pages 35...45.
18
Input and Output
Buffers
(continued)
Please note the
basic procedure on
16 and 30...34
and the examples
on pages 35...45.
18 E
Function Description

Input and Output Buffers

In order to transmit commands and data between the BIS C-60_2 and the host system, the
latter must prepare two fields. These two fields are:
– the output buffer
for the control commands which are sent to the BIS Identification System and
for the data to be written.
– the input buffer
for the data to be read and
for the designators and error codes which come from the BIS Identification System.
The possible setting values are stored in the GSD file.
The buffer size can be selected between 4 and 128 bytes in steps of 2 bytes. This must be
given by the master during parametering. The total buffer size is divided into 2 ranges:
Buffer range 1 for Read/Write Head 1; size is specified in paramter byte 6.
Buffer range 2 for Read/Write Head 2; size = total buffer size – buffer size of Read/Write
Head 1. See 18 for example.
If a buffer size of less than 6 bytes (8 bytes with double bit header) is used for a read/write
head, no read/write job can be carried out.
Buffer size – 1 = number of bytes read without double bit header;
Buffer size – 2 = number of bytes read with double bit header.
Function Description
Input and Output Buffers
Example: The 82 bytes for the total buffer need to be distributed. An input/output buffer of
46 bytes is assigned to Read/Write Head 1. This results in an input/output buffer of 36 bytes
for Read/Write Head 2.
Procedure: The buffer size for Read/Write Head 1 is set to 46 bytes. This means using the
parameter byte 6 to enter Hex value 2E (corresponds to 46 decimal), which corresponds to
binary 00101110.
PLC Organisation: The buffer range starts at input byte IB 32 and output byte OB 32.
Result:
Read/Write Head 1: Subaddress 00
(R/W 1) Input buffer
Output buffer
Read/Write Head 2: Subaddress 00
(R/W 2) Input buffer
Output buffer
Note that these buffers can be in two different
sequences depending on the type of control.
The following description is based on sequence 1!
IB 0 / OB 0
IB 32 and OB 32
IB 32 to IB 77
OB 32 to OB 77
IB 78 and OB 78
IB 78 to IB 113
OB 78 to OB 113
Sequence 1
Subaddress 00
01
02
03
04
05
06
07
E 17
PLC buffer
Buffer for R/W 1
Buffer for R/W 2
Sequence 2
Subaddress 01
00
03
02
05
04
07
06