Safety; Intended Use; Installation And Startup; General Safety Instructions - Balluff BNI IOL-75x-K007 Betriebsanleitung

IO-Link Valve Plug
BNI IOL-75x-...-K007
2

Safety

2.1. Intended use

2.2. Installation and
startup
2.3. General safety
instructions
2.4. Resistance to
Aggressive
Substances
Hazardous
voltage
www.balluff.com
This guide describes the Balluff IO-link valve block interface BNI IOL-75x-... to control valve
block devices of different manufacturers.
Connection to the host interface IO-Link master is made through the IO-link protocol.
Attention!
Installation and startup are to be performed only by trained specialists. Qualified
personnel are persons who are familiar with the installation and operation of the
product, and who fulfills the qualifications required for this activity. Any damage
resulting from unauthorized manipulation or improper use voids the
manufacturer's guarantee and warranty. The Operator is responsible for
ensuring that applicable of safety and accident prevention regulations are
complied with.
Commissioning and inspection
The operating company shall be responsible for observance of locally applicable safety
instructions.
Before commissioning, carefully read the operating manual.
The system must not be used in applications in which the safety of persons is dependent on
the function of the device.
Authorized Personnel
Installation and commissioning may only be performed by trained specialist personnel.
Intended use
Warranty and liability claims against the manufacturer are rendered void by:
• Unauthorized tampering
• Improper use
• Use, installation or handling contrary to the instructions provided in this operating
manual
Obligations of the Operating Company
The device is a piece of equipment from EMC Class A. Such equipment may generate RF
noise. The operator must take appropriate precautionary measures. The device may only be
used with an approved power supply. Only approved cables may be used.
Malfunctions
In the event of defects and device malfunctions that cannot be rectified, the device must be
taken out of operation and protected against unauthorized use.
Attention!
The BNI modules always have good chemical and oil resistance. When used in
aggressive media (such as chemicals, oils, lubricants and coolants, each in a
high concentration (i.e. too little water content)), the material must first be
checked for resistance in the particular application. No defect claims may be
asserted in the event of a failure or damage to the BNI modules caused by such
aggressive media.
Attention!
Disconnect all power before servicing equipment.
Note
In the interest of product improvement, the Balluff GmbH reserves the right to
change the specifications of the product and the contents of this manual at any
time without notice.
1