Balluff BAE SA-OH-059-YI-DP02 Betriebsanleitung Seite 50

BAE SA-OH-059-YI- ----
Photoelectric Sensors
8
Menu structure (continued)
Two Value Teach
With Two-Value Teach, the switching point (setpoint) is
defined via two teach points. The average value of the two
teach points defines the setpoint. This is a static process
as well, i.e., each teach point is defined statically. The
teach process can be performed independently for each
switching point in Two-Point Mode or Window Mode. The
teach process is concluded with the Apply command; this
is only possible if each of the two teach points has been
taught. Alternatively, the teach process can be interrupted
with a Cancel command. All incomplete teach point pairs
are thereby lost.
Low
Workflow:
1. Teach SP1 TP1
2. Teach SP1 TP2
3. Teach Apply
Fig. 8-18: Two Value Teach in Single Point Mode
Low
SP2
Workflow:
1. Teach SP2 TP1
2. Teach SP2 TP2
3. Teach Apply (optional)
4. Teach SP1 TP1
5. Teach SP1 TP2
6. Teach Apply
TP1
Fig. 8-19: Two Value Teach in Two Point Mode
18 english
High
SP1
Measurement
value
TP1 TP2
High
SP1
Measurement
value
TP2 TP1 TP2
Single Point Mode - Single Value Teach
Low
SP1 SP1
-Hys
Workflow:
1. Teach SP1
Fig. 8-20: Single Point Mode - Single Value Teach no offset
Alarm
Low
SP1 SP1 SP1 SP1
-3Hys -2Hys -Hys
Workflow:
1. Teach SP1
Fig. 8-21: Single Point Mode - Single Value Teach neg. offset
Low
TP
Workflow:
1. Teach TP
Fig. 8-22: Single Point Mode - Single Value Teach pos. offset
High
Alarm
Measurement
SP1
Messwert
value
+Hys
High
Measurement
Messwert
value
High
Alarm
SP1 SP1 SP1
-Hys (TP+3Hys) +Hys
Measurement
Messwert
value