Type; Logic; Signal Source; Ssc Mode - Balluff BAE SA-OH-059-YI-DP02 Betriebsanleitung

BAE SA-OH-059-YI- ----
Photoelectric Sensors
8
Menu structure (continued)
8.6.2

Type

The output can be configured with Type.
Value Meaning
PNP PNP
NPN NPN
Push-Pull Push-Pull
Tab. 8-11: Configuration – Type
8.6.3

Logic

With Logic, the input/output can be configured as inverted
or normal.
Value Meaning
Normal Normal
Inverted Inverted
Tab. 8-12: Configuration – Logic
8.6.4

Signal Source

With Signal Source, the internal signal source for the pin
can be selected. Various signal sources are available that
can be output or read on a pin.
Value
Digital Output
Pin 4
Delay Ch 1
Pin 2
Delay Ch 2
Alarm
Digital Input
Pin 2
Teach-In
Transd.En.
CounterRst
Pin 5 (only in Dxxx)
Teach-In
Transd.En.
CounterRst
Tab. 8-13: Configuration – Signal Source
* if pin 5 is used as teach-in at the same time, the teach
confirmation pulses are output with a length of 100 ms via
pin2 parallel to the alarm pulses.
24 english
Description
PNP output
NPN output
Push-Pull output
Description
Non-inverted logic
Inverted logic
Meaning
Signal Delay Channel 1
Signal Delay Channel 2
Signal Quality Bad *
Teach-in
Transducer Enable
Switching Counter Reset
Teach-in
Transducer Enable
Switching Counter Reset
8.6.5

SSC Mode

Value Meaning
Single Pt Single Point
Window Window
Two Pt Two Point
Dyn. neg Dynamic, falling
edge
Dyn. pos Dynamic, rising
edge
Th.Trk Threshold
neg tracking, falling
edge
Th.Trk Threshold
pos tracking, rising
edge
Tab. 8-14: Configuration – SSC Mode
8.6.6

Power Mode

The power mode "High" should only be used if the high
power is really needed in order to avoid unnecessary high
current consumption and heating of the BAE. The modes
"Low" and "Extra Low" are mainly intended for transmitted
light barriers with short distance between transmitter and
receiver.
The LED pulse peak current depends on the speed mode:
Standard,
Sync6,
Descrip- Sync8,
Value
tion Precision,
High Precision 25 Hz
High Precision 30 Hz
High High 180mA
Std Standard 100mA
Low Low 55mA
Xlow Extra Low 18mA
Tab. 8-15: Configuration – Power Mode
Description
Single-Point Mode
(SP1 activated)
Window Mode
(SP1 + SP2 activated)
Two-Point Mode
(SP1 + SP2 activated)
Single point mode, with
dynamic signal evaluation,
falling edge
Single point mode, with
dynamic signal evaluation,
rising edge
Single point mode, with
switching threshold tracking,
falling edge
Single point mode, with
switching threshold tracking,
rising edge
Super-
Fast
fast
90mA 60mA
50mA 33mA
27mA 18mA
18mA 18mA