Safety Instructions; Environment - Weidmuller THM MultiMark Bedienungsanleitung

1.3

Safety Instructions

• The device is configured for voltages of 100
to 240 V AC. It only has to be plugged into a
grounded socket.
• Only connect the device to other devices which
have a protective low voltage.
• Switch off all affected devices (computer, printer,
accessories) before connecting or disconnecting.
• The device may only be used in a dry environ-
ment, do not expose it to moisture (sprays of wa-
ter, mists, etc.).
• Do not use the device in an explosive atmo-
sphere.
• Do not use the device close to high-voltage
power lines.
• If the device is operated with the cover open,
ensure that people's clothing, hair, jewelry etc. do
not come into contact with the exposed rotating
parts.
• The device or parts of it can become hot while
printing. Do not touch during operation, and allow
to cool down before changing material and before
disassembly.
• Risk of crushing when closing the cover. Touch
the cover at the outside only. Do not reach into
the swivel range of the cover.
• Perform only those actions described in this oper-
ating manual.
Work going beyond this may only be performed
by trained personnel or service technicians.
• Unauthorized interference with electronic mod-
ules or their software can cause malfunctions.
• Other unauthorized work on or modifications to
the device can also endanger operational safety.
• Always have service work done in a qualified
workshop, where the personnel have the techni-
cal knowledge and tools required to do the nec-
essary work.
• Warning stickers must therefore not be removed,
as then you and other people cannot be aware of
dangers and may be injured.
• The maximum sound pressure level is less than
70 dB(A).
2599430000/00/04.2019
Danger to life and limb from power sup-
ply.
Do not open the device casing.
This is a class A product. In a domestic
environment this product may cause ra-
dio interference in which case the user
may be required to take adequate mea-
sures.
1.4

Environment

Obsolete devices contain valuable recyclable materi-
als that should be sent for recycling.
Send to suitable collection points, separately from
residual waste.
The modular construction of the printer enables it to
be easily disassembled into its component parts.
Send the parts for recycling.
The electronic circuit board of the de-
vice is equipped with a lithium battery.
Take old batteries to collection boxes in
shops or public waste disposal centers.
Introduction
DANGER!
WARNING!
35