Hendi 250VV Bedienungsanleitung Seite 13

STOP
For the stop control push the button
FUNCTIONING SAFETY
If the machine is under stress, or is submitted to too
long functioning times or submitted at overloaded,
the same stops immediately for the thermal protection
VOLTAGE LACKING
In case of electric feeding breaking or if the machine
is disconnected from the electric net, this last one
will be able to be restarted only following the start-
CONTROLS AND VERIFICATIONS BEFORE STARTING
VERIFICATION / CONTROL
Check that:
• There aren't inside the pot
extraneous objects
Check the cleaning:
• Of the machine external sides
• of the tool along its surface
• of the tool external sides
Check the integrity:
• of the fixed protections
• of the machine body
Check the functionality:
• of the control system
parts / control about
the safety;
• of the control devices.
Check the absence:
• of strange noises after
the starting
For any intervention type or for the parts change
that are damaged, activate the maintenance ser-
vice. The possible change must happen with manu-
.
MODALITIES AND CHECKS
Sight control of the indicated parts, to check of objects or extraneous bodies
lacking as for example different tools, clothes, etc ... and that there isn't however
the food product
All indicated parts surfaces, before the machine use must be checked visually to
verify their cleaning. In case of molds presence or other type of dirtiness, provide
with the cleaning procedure in accordance with the chapter 5 indications.
All fixed protections, etc.. must perform the function for which have been
foreseen. Indicated parts sight check to verify their integrity in their surface
external part. The parts must be however changed at the first erosion signals
or breaking (cfr. Authorized Assistance Center).
All devices must perform the function for which have been foreseen. Control
directly the devices so that these ones determine the waiting function.
The actuators and all parts must be however changed to the first erosion signals
or breaking (cfr. Authorized Assistance Center).
During the functionality checking of the control devices, if there are strange
noises, due for example to a seizing or mechanical breaks, stop immediately
the machine and activate the maintenance service.
functioning. In this case wait that it is completely
cooled before proceeding to the starting function.
ing function, after the electric feeding back or the
reconnection to the electric net.
facturer original products or at least of quality,
safety and equivalent characteristics. For analysis
contact the Authorized Assistance Center.
EN
13