Physik Instrumente Mercury C-863 Benutzerhandbuch Seite 277

1005 PI_CNTR_CONTROLLER_BUSY
1006 PI_CNTR_INVALID_IDENTIFIER
1007 PI_CNTR_UNKNOWN_VARIABLE_OR_ARGUMENT
1008 PI_CNTR_RUNNING_MACRO
1009 PI_CNTR_MACRO_INVALID_OPERATOR
1010 PI_CNTR_MACRO_NO_ANSWER
1011 PI_CMD_NOT_VALID_IN_MACRO_MODE
1024 PI_CNTR_MOTION_ERROR
1063 PI_CNTR_EXT_PROFILE_UNALLOWED_CMD
1064 PI_CNTR_EXT_PROFILE_EXPECTING_MOTION_ERROR
1065 PI_CNTR_PROFILE_ACTIVE
1066 PI_CNTR_PROFILE_INDEX_OUT_OF_RANGE
1071 PI_CNTR_PROFILE_OUT_OF_MEMORY
1072 PI_CNTR_PROFILE_WRONG_CLUSTER
1073 PI_CNTR_PROFILE_UNKNOWN_CLUSTER_IDENTIFIER
1090 PI_CNTR_TOO_MANY_TCP_CONNECTIONS_OPEN
2000 PI_CNTR_ALREADY_HAS_SERIAL_NUMBER
4000 PI_CNTR_SECTOR_ERASE_FAILED
4001 PI_CNTR_FLASH_PROGRAM_FAILED
4002 PI_CNTR_FLASH_READ_FAILED
C-863 Mercury Controller
Controller is busy with some lengthy
operation (e.g. reference move, fast
scan algorithm)
Invalid identifier (invalid special
characters, ...)
Variable or argument not defined
Controller is (already) running a
macro
Invalid or missing operator for
condition. Check necessary spaces
around operator.
No answer was received while
executing WAC/MEX/JRC/...
Command not valid during macro
execution
Motion error: position error too large,
servo is switched off automatically
User Profile Mode: Command is not
allowed, check for required
preparatory commands
User Profile Mode: First target
position in User Profile is too far from
current position
Controller is (already) in User Profile
Mode
User Profile Mode: Block or Data Set
index out of allowed range
User Profile Mode: Out of memory
User Profile Mode: Cluster is not
assigned to this axis
Unknown cluster identifier
There are too many open tcpip
connections
Controller already has a serial
number
Sector erase failed
Flash program failed
Flash read failed
MS205D
9 GCS-Befehle
Version: 2.0.0 269