Symbols; Designations; Abbrevations - Bosch Rexroth PRC7000 MGDM-BASIC Betriebsanleitung

R911407405 | Rexroth PRC7000 MGDM-Basic
1.3.2

Symbols

The following symbols mark notes that are not safety-relevant but increase the
understanding of the documentation.
Meaning of the symbols
Tab. 5:
Symbol Meaning
If this information is disregarded, the product cannot be
used and or operated to the optimum extent.
Single, independent step

1. Numbered step:
2. The numbers specify that the Steps are completed one
after the other.
3.
1.3.3

Designations

This documentation uses the following designations:
Designation
Tab. 6:
Designation Meaning
BCD
Binary coded decimal number
ELMO
Electromotive
HIP
Hall Installation Plate
KSR
Constant current regulation
MGDM Measuring Gun data Module
MOV
Metal oxide varistor
PELV Protective Extra Low Voltage
PHA Phase angle
PRC 7000 Process Resistance Welding Control
PRI 7000 Process Resistance Welding Interface
PSF
Prozess stability
PSG xxxx
Medium-Frequency Welding Transformer 1000Hz
PU
Power Unit
STC TEACH Sheet Thickness Combination, teaching
Process quality. Value for the welding quality, derived from
UIP
the resistance characteristic of the current weld.
UIR UI control
XGM Interfaces of MGDM
WIC Weld Interface Controller (internal realtime bus)
1.3.4

Abbrevations

For information on the abbreviations used in this documentation, refer to Tab. 1:
Required and supplementary documentation Rexroth PRC7000 Process Resistance
Welding Control Instructions.
Bosch Rexroth AG 47/80