Electrical Connection - Bosch Rexroth PRC7000 MGDM-BASIC Betriebsanleitung

56/80 Bosch Rexroth AG | Electric Drives and Controls
3.3

Electrical connection

Incorrect voltage supply
Possibility of damage to the electrical equipment!
Check whether the supply voltage coincides with the nominal voltage

indicated on the nameplate of the product!
The product may only connected to the mains if these values coincide.
Make sure that fluctuations or deviations of the supply voltage

_
from the nominal value always range within the permitted tolerance
limits (refer to technical data).
Capacitive or inductive interferences in the cables
Possibility of function disturbances!
Install the power lines and control cables separately.

The following clearances are recommended:
> 100 mm with parallel installation of cables < 10m,
> 250 mm with parallel installation of cables > 10m.
The product should be installed in close proximity to the welding

equipment in order to keep the lengths of the necessary connection cords
to a minimum.
Plugging or unplugging modules or connectors/terminals into/from live
systems
Possibility of damage to the electrical equipment, unexpected
plant reactions!
Unless described otherwise, never unplug or plug any connectors/

terminals on live systems.
R911407405 | Rexroth PRC7000 MGDM-Basic
NOTICE