Operating The Product; Retrofits And Modifications By The Operator - Bosch Rexroth PRC7000 MGDM-BASIC Betriebsanleitung

R911407405 | Rexroth PRC7000 MGDM-Basic
2.6.5

Operating the product

High dynamic forces and extremely fast movements
Danger of impacts, bruises, entanglement and burns!
You should always be aware of the possibility that motions can be

triggered by faults of the system and behave with the appropriate
care and sense of responsibility.
Do not ever deactivate any safety– relevant functions!

Always stay outside the danger area of the welding system when it

is running!
Make sure that moving system elements are halted safely before

accessing the danger area of the system!
Robots and fixing elements may generate very high dynamic
forces and extremely fast movements. In addition, expulsion may
occur during a welding schedule.
Fault reset
Dangerous machine movements possible!
Prior to acknowledging error messages, make sure that there is

no-one in the hazard area of the welding equipment!
If the start signal is present when an error message is acknowledged,
the weld timer will start its program run immediately.
Damaged system parts
Possibility of reduction of safety of persons/systems, function
disturbances/restrictions!
Before starting to work, subject the plant to a reasonable, practical

check for possible damages (e.g. visual inspection).
Report any damages and malfunctions of the unit to your supervisor

and servicing or repair department immediately.
2.6.6

Retrofits and modifications by the operator

Modification of the product
Possibility of reduction of safety of persons/systems, function
disturbances/restrictions!
Modifications of the product are normally not permitted.

If you think that you can only use the product after a change, you
have to contact us before performing the change. This is the only
way to find out whether or not changes can be made safely.
You may, in any case, only perform changes on the product with
our written consent!
Bosch Rexroth AG
WARNING
WARNING
53/80