Display Of Information; Safety Instructions; Symbols; Designations - Bosch Rexroth IndraControl VCP05.2 Projektierungsbeschreibung

22/38 Bosch Rexroth AG | Bedienoberfläche Schweissen / Resistance welding user interface VCP05.2 | R911172348
To this Documentation
1.3

Display of information

In order to enable you to work with your product in a fast and safe way, uniform
Safety instructions, symbols, terms and abbreviations are used. For a better
understanding they are explained in the following sections.
1.3.1

Safety instructions

The Safety instructions refer to Tab. 1: Required and supplementary
documentation Rexroth PSI6xxx Weld Timer with Medium-Frequency Inverter
Instructions and Rexroth Weld Timer Safety and user information.
1.3.2

Symbols

The following symbols mark notes that are not safety-relevant but increase the
understanding of the documentation.
Tab.2: Meaning of the Symbols
Symbol Meaning
If this information is disregarded, the product cannot be
used and or operated to the optimum extent.
Single, independent step

1. Numbered step:
2. The numbers specify that the Steps are completed one
after the other.
3.
1.3.3

Designations

This documentation uses the following designations :
Tab.3: Designation
Designation Meaning
BOS 6000 Bedienoberfläche Schweißen (Welding Software)
PSG xxxx
Medium-Frequency Welding Transformer 1000Hz
VCP05.2
Small Operator Terminal
1.3.4

Abbrevations

The in this documentation used abbrevations refer to Tab. 1: Required and
supplementary documentation Rexroth PSI6xxx Weld Timer with Medium-
Frequency Inverter Instructions.