Operation - Bosch Rexroth PRC7000 MGDM-BASIC Betriebsanleitung

R911407405 | Rexroth PRC7000 MGDM-Basic
Electrostatic charge
Possibility of damage to the electrical equipment!
Observe all precautions for ESD protection when handling modules

and components and avoid electrostatic discharge.
Observe the following protective measures for modules and

components sensitive to electrostatic discharge (ESD):
Personnel responsible for storage, transport, and handling

must have training in ESD protection.
ESD-sensitive components must be stored and transported in

the prescribed protective packaging.
ESD-sensitive components may only be handled at special
ESD workplaces.
Personnel, working surfaces, as well as all equipment and

tools which may come into contact with ESD-sensitive
components must have the same potential (e.g. by grounding).
Wear an approved grounding bracelet. The grounding bracelet

must be connected with the working surface through a cable
with an integrated 1 megaohm resistor.
ESD-sensitive components may by no means come into contact

with chargeable objects, including most plastic materials.
When inserting or removing ESD in/from other devices, the device

must be safely disconnected from the supply.
3.4

Operation

High-frequency interference
Possibility of interference with other devices in the environment!
Make sure that no other devices or their functioning can be affected

if the present product is operated.
The product is part of class A resistance welding equipment.

Class A resistance welding equipment is designed for industrial
networks (also refer to „ intended use" chapter 2.2).
Use in the public low-voltage network which supplies e.g.
residential areas therefore requires special measures.
Bosch Rexroth AG
NOTICE
NOTICE
57/80