BACHTENKIRCH Tracy Montage- Und Betriebsanleitung Seite 16

Attention! Important safety note:
Children's bicycles are produced pre-assembled ex works. If the bicycle was not delivered to you ready to ride due
to transportation issues, please understand that additional assembly work (so-called final assembly) is required.
The final assembly must be performed by an adult.
Please read this illustrated assembly and maintenance guide carefully. It shows you how you can make this
children's bicycle ready to ride in a few simple steps – especially before first use.
This assembly and operating manual provides you with important tips for the safe use as well as the care and maintenance of
individual components of this children's bicycle.
For safety reasons, this children's bike may only be used under adult supervision.
All critical information that you must absolutely heed is indicated by the following symbols:
Attention, warning – this is about the safety of your child! You must observe the instructions. Please be advised that it is
imperative to pass these instructions on to other users of the bicycle.
In the event of failure to heed these safety instructions, both the warranty and liability shall expire.
Please contact a specialist/dealer.
Initial checks to establish riding readiness (put into service)
Caution:
To ensure safety, it is imperative to conduct a technical check prior to the first ride and every subsequent ride.
This means that the following checkpoints must be observed to get the bike ready for riding (and for the final assembly):
1. Compliance with intended use...................................................................
2. Compliance with the general safety instructions..........................................
3. Tension of individual spokes and smooth wheel rotation...............................
4. Valves, consistency and air pressure of the tyres.............. ..........................
5. Secure fit of the cranks on the bottom bracket spindle............................. ....
6. Correct and secure fastening of the pedals in their cranks.............................
7. Adjustment of the saddle height to the proper body size........................... ....
8. Observe the STOP marking / secure fitting of the saddle post........................
9. Fasten handlebar orientation and stem......................................................
10. Ensure secure fit of the handlebar shaft and observe the STOP marking..........
11. Secure fit of the wheel hubs and tightened hub axle nuts......................... ......
12. Condition and tension of the chain...........................................................
13. All screws and nuts tightened securely........................................................
14. Adjustment and functioning of the braking system.......................................
15. Functioning of the bell...........................................................................
16. If training wheels are used, ensure that they are securely fastened.................
Please see the reverse of these instructions for the proper torque values for tightening the screw couplings.