Storage And Transportation; Technical Specifications - 3M 9100 MP Benutzerhandbuch

the face seal and secure it under your chin.
Adjust the face seal tightly to suit the shape of
the face (see fig G:7). If needed, lift the visor
and adjust the airflow deflector. When fully
opened, more airflow is directed across the
face. When partially closed, a portion of the air
is directed towards the visor. (see fig H:1)
It is important that the face seal is correctly
mounted and fitted to provide the correct
protection factor. Do not remove the welding
helmet or turn off the air supply until you
have vacated the contaminated area.
Headtops used in aggressive environments
or outside in direct sunlight may need to be
replaced more frequently than headtops
used occasionally indoors.
3M recommends a maximum life (shelf-life
plus in-use life) of 5 years from the date of
manufacture when stored in accordance with
the recommended storage conditions for the
head protection part (helmet). Note: date of
manufacture is moulded on the helmet
plastic part.
When working in environments with intense
light radiation that gives heat, environments
with welding spatter or when high visibility is
required, 3M™ Speedglas™ Helmet Cover
9100 MP / 9100 MP-Lite shall be used.
CLEANING/ DISINFECTION INSTRUCTIONS
Clean/disinfect the welding helmet with a mild
detergent and water.
To avoid damage to the product do not
use solvents or alcohol for cleaning or
disinfection.
MAINTENANCE
Helmets/bump caps subjected to severe
impact should be replaced.
Replacement of:
• visor plate see fig. (C:1-C:4)
• welding filter see fig. (D:1 -D:6)
• head suspension see fig. (E:1)
• sweatband see fig. (F:1)
• face seal. see fig. (G:1-G:6)
• ratchet see fig. (I:1-I:2)
• pivot kit see fig. (J:1-J:3)
Removal of Flip-up (see fig L:1)
Worn out product parts should be disposed
of according to local regulations.

STORAGE AND TRANSPORTATION

When stored as stated in technical specification,
the expected shelf life of the product is five
years. The original packaging is suitable for
transporting and storage.
The original packaging
transporting.

TECHNICAL SPECIFICATIONS

Weight welding helmet 9100 MP
(excl welding filter):
Weight welding helmet 9100 MP-Lite
(excl welding filter):
Note: 3M™ Speedglas™ Welding Helmet 9100
MP with recommended 3M™ Peltor™ Earmuffs
meets a 3M Technical Specification based on
EN12941. The Technical Specification deviates
from EN12941:1998 + A2:2008 by not applying
the Mass requirements (Clause 6.16).
Viewing area visor plate:
Operating conditions:
Storage conditions:
Extended storage
conditions:
Expected service life:
Head sizes:
Material :
Welding helmet
Silver front frame
Side windows
Head suspension
Safety helmet
Bump cap
is suitable for
1000 g
810 g
100 x 170 mm
-5°C to +55°C,
RH ≤ 90%,
non-condensing
conditions
-30°C to +50°C,
RH ≤ 90%,
non-condensing
conditions
+4°C to +35°C,
RH ≤ 90%,
non-condensing
conditions
5 years
depending on
conditions of use
51-64
PPA
PA
PC
PA, PP, TPE, PE
PC + PBT
HDPE
3