HEIDELBERG Suprasetter 106 Installation Seite 98

Autoloader APL Option
Note: On the APL 106 K, the 5m Ethernet cable (Fig. 6/1) is already fitted to the control ter-
minal (Fig. 6/2), the 20m Ethernet cable, like the Ethernet switch, is packed in one of the
accessory kit boxes. After you open the panel below the control terminal, you can either
route the connected Ethernet cable through openings Fig. 6/3 and Fig. 6/4 to the outside
of the machine or you can fit the 20m cable instead of the 5m cable to the control terminal,
conduct it through both cable ducts (Fig. 6/5 and 6) in the interior of the APL and conduct
it with the compressed air and power connection cables to the outside of the machine.
2
1
5
6
Fig. 6 Possible routing of the network cable
96
3
4