HEIDELBERG Suprasetter 106 Installation Seite 71

Fig. 58 Hose connection
Fig. 59 Laser module hose connection
Sensitive contacts
Make sure not to touch the PCB contacts (Fig. 60/3)!
Suprasetter 106 – Installation
Push hose (Fig. 58/5) into the hose connector (Fig.
58/1) until the resistance of the collet (Fig. 58/3)
can be felt.
Exert strong pressure to slide the hose approx. 2-3
mm through the O-ring (Fig. 58/2) (second resis-
tance).
Slightly pull back the hose so the collect grips the
hose. The distance between the cap (Fig. 58/4)
and the connector is then approx. 1 mm.
Please note that just like with the compressed air
connection you must overcome a resistance twice
with the connections on the laser module:
1. with the collet and
2. with the O-ring.
You can tell that a hose was pushed into the con-
nector far enough if the visible part of the metallic
sleeve is smaller than 5 mm (Fig. 59).
Again, you must pull back the hose somewhat so
the collet grips the hose.
Align the hoses as shown in Fig. 57/1. Install the
laser modules into their respective slots according
to the configuration list in the machine data sheet.
NOTICE
Installation
69