HEIDELBERG Suprasetter 106 Installation Seite 57

Fig. 30 Transport safeguard: Roller / VCT bar right
Fig. 31 Transport safeguard: Feed motor
Fig. 32 Swing up front unit
Suprasetter 106 – Installation
Cut and remove the cable tie (Fig. 30/1) securing
the roller.
Cut and remove the cable tie (Fig. 30/2) securing
the VCT bar.
Loosen the four screws (Fig. 31/3) and remove the
bracket (Fig. 31/2) securing the feed motor (Fig.
31/1).
Loosen the two screws (Fig. 32/1) (SW3) and swing
up the front unit (Fig. 32/2).
Installation
55