Configure Diag; Toggling The Language - HEIDELBERG Suprasetter 106 Installation

Installation

Configure DIAG

Prerequisite: The CTP User Interface must not be running.
Fig. 71 Speedway Target Configuration
Note: In the "Interface Settings" do not select "Suprasetter 105" or "Suprasetter 106" but
simply "Suprasetter" (without any affix)!
Select "Suprasetter" as the target in the "Interface Settings" window, set the connected port as well
as the Baud rate and confirm with "OK".

Toggling the Language

Fig. 72 DIAG properties
78
Start "Diagnose Suprasetter" from the Start menu.
The "Speedway Target Configuration" window, in
which you must set "Main Target" to "active",
appears on top of the large diagnosis window.
Use the "Select" button to open C:\Program-
Files(x86)\Heidelberg\CTP\Diagnose Supraset-
ter\DIAG Suprasetter\Diag Suprasetter.tdb.
You can toggle the language between German
and English for the DIAG Suprasetter program; to
do so, select "Options / Properties", go to the
"Options" tab and check or uncheck "English".