HEIDELBERG Suprasetter 106 Installation Seite 58

Installation
Fig. 33 Transport safeguard: Cylinder - VCT bar
Fig. 34 Transport safeguard: Punch bar
Fig. 35 Punch bar lock bar
Fig. 36 Transport safeguard: Swivel table
56
Pull out and remove three foam rubber strips (Fig.
33/1) between the cylinder and the VCT bar. To do
this, raise the VCT bar and roller manually.
Unscrew the screws on the left and right transport
safeguards of the punch bar and remove the
brackets (Fig. 34/1) if the Suprasetter comes with
the Punch option.
Throw the lock bar (Fig. 35/1) on the left and right
side of the punch bar and fix the punch bar in
place.
Unscrew three screws (Fig. 36/2) on either side of
the swivel table and remove the transport safe-
guard (brackets, Fig. 36/1).