HEIDELBERG Suprasetter 106 Installation Seite 60

Installation
Fig. 40 Transport safeguard suck carriages
Fig. 41 Transport safeguard unloading table
Fig. 42 Transport safeguard: suspended exhaust
58
Cut and remove the cable ties (Fig. 40/1) around
the suck carriages.
Push the load table back in and let it engage,
insert both locking screws (Fig. 39/1) again and fit
the cable protection (Fig. 38/2) again.
Cut and remove the cable ties (Fig. 41/1) around
the suck carriages of the unloading table.
Swing down the front unit again and secure it with
the two screws (Fig. 32/1).
If the Suprasetter comes with the "Exhaust"
option, cut and remove the cable ties (Fig. 42/1)
securing the suspended exhaust unit.