HEIDELBERG Suprasetter 106 Installation Seite 75

Beware of short circuit
Do not tilt the laser module while the Suprasetter is switched on.
Fig. 66 Connector X380
Note: Connector X380 must not be fitted if a slot is not occupied by a laser module.
Do not twist the hoses
Risk of overheating
Never operate the laser without cooling water!
Suprasetter 106 – Installation
NOTICE
Open the housing and check if connector X380
(Fig. 66/1) is fitted (not necessary for fitting
according to the machine data sheet).
NOTICE
NOTICE
Installation
73