HEIDELBERG Suprasetter 106 Installation Seite 74

Installation
Fig. 64 Fit hoses
Fig. 65 Protect elbow connectors from wear
Avoid wear
Worn elbow connectors (Fig. 65/3) cause coolant to leak, which in turn can lead
to short circuits.
Take note of the following items relating to the laser module to conclude installation (see
Work, page 86):
• Perform a visual check of the laser module for any coolant leaks once the chiller has started cir-
culating the coolant.
• With the Suprasetter switched off, check that the laser module is seated correctly (unhook
spring / reposition module / tighten spring again) if an error message about the laser module
displays after startup and initialization of the Suprasetter.
72
Vigorously push the hoses for the modules (Fig.
64/2) as far as they will go into the couplings (Fig.
64/1).
Push the elbow hose connectors (Fig. 65/1) down
(Fig. 65/arrow) until they no longer rub on the on
the sheet metal (Fig. 65/2) on which the punch
waste boxes are standing.
NOTICE
Concluding