HEIDELBERG Suprasetter 106 Installation Seite 64

Installation
Fig. 48 Configuration of the cable for connection of the Suprasetter
Circuit terminal PT4
Connection data
Connection type push-in connection
Connection compliant with IEC 60947-7-1
Conductor cross-section rigid
Conductor cross-section flexible
Conductor cross-section flexible with wire end sleeve without plastic sleeve
Conductor cross-section flexible with wire end sleeve with plastic sleeve
Insulation length
Operating tool
Blade thickness
Blade width
62
If a preconfigured cable of Heidelberger Druck-
maschinen AG is not used, the information in the
following table and the diagram must be observed
during configuration of the cable.
0.2 - 6 mm²
24 - 10 AWG
0.2 -4 mm²
24 - 12 AWG
0.25 - 4 mm²
0.25 - 4 mm²
10 - 12 mm
0.6 mm
3.5 mm