Installation
Fig. 9 Cover and cover plate
Fig. 10 Back panel
46
Loosen three screws (Fig. 9/3) on each side of the
cover plate and take off the cover plate.
Loosen two screws (Fig. 9/2) on both sides of the
cover and four screws (Fig. 9/1) at the rear and lift
off the cover.
Only for stand-alone and semi-automatic versions
(not with the automatic loader version):
Loosen the three clips (Fig. 10/1) in the rear panel
by 1/4 turn and take off the rear panel.