HEIDELBERG Suprasetter 106 Installation Seite 73

Fig. 62 Eccentric
Leaking coolant
Immediately wipe off any spilled coolant. Make sure no coolant reaches the PCB
(Fig. 60/3)!
Fig. 63 Pressure reducer
Do not twist the hoses.
Suprasetter 106 – Installation
Guide the eccentric (Fig. 62/3) with the pin
upwards through the (right) hole (Fig. 62/1) and
hook the pin (Fig. 62/2) into the eye of the spring
hanging down.
Tighten the spring by turning the large wheel of the
insertion tool by approx. 1/2 turn in clockwise
direction as far as the stop.
Check the module seating: The spring must auto-
matically pull it back to its final position on the
three balls when you tilt it slightly with your hand.
NOTICE
Take out the pressure reducer (Fig. 63/2) with the
two short hoses (Fig. 63/1).
NOTICE
Installation
71