Optional Accessories; Instruction Manual - Use And Maintenance - Comet K Steel Bedienungs- Und Wartungsanleitung

Inhaltsverzeichnis

Verfügbare Sprachen

• high pressure cleaner;

• high pressure delivery hose;

• spray gun;

• lance hose;

• bag of accessories with:

- instruction manual - safety precautions;

- instruction manual - operation and maintenance;

- declaration of conformity;

- booklet giving the assistance centres;

- warranty certificate;

- ejector kit;

- suction kit comprising: fitting, gasket and clamp;

- nozzle cleaning pin.

If any problems arise please contact your dealer or an authorised assistance centre.

You can add the following range of accessories to the standard ones supplied with your high pressure

cleaner:

• sandblasting lance: designed to smooth surfaces, removing rust, paint, encrustations, etc.;

• drain cleaning kit: designed to unclog pipes and ducts;

• different types of lances and nozzles;

• rotating brush: designed for cleaning fragile surfaces;

• rotating nozzle: designed for removing stubborn dirt;

• foam lance: designed for a more efficient distribution of the detergent;

• hose reel: to increase working range thanks to a longer hose and practical housing for it.

Please contact your dealer to know more about the complete accessory range.

INSTALLATION - ASSEMBLING THE ACCESSORIES

• Unwind the high pressure hose (25) and screw the end (without the quickfit coupling) onto the spray

gun (17) thread and tighten well with two 22 mm fixed jaw spanners (not supplied). Operation D in

Fig. 13.

• Connect the quickfit coupling (26) to the water outlet fitting (12), screw down and tighten the ring nut

by hand. Operation E in Fig. 13.

• K Steel (see Fig. 8): insert the gasket (19), the filter cartridge (35) in the water inlet fitting (13) and screw

the water inlet hose barb (18) into it. Operation L in Fig. 14.

• K Steel XL (see Fig. 9): insert the gasket (19) in the water inlet fitting (13) and screw the water inlet

bent hose barb (36) into it. Operation M in Fig. 14.

• Follow the instructions given in the "Routine maintenance" and "Special Maintenance" paragraphs.

• Take the high pressure cleaner to the place of work using the handle (2).

• Using the clamp (34) supplied, fix a supply hose with an inside diameter of 19 mm/0.75 in to the water

inlet hose-end fitting (18) or (36). Operation I in Fig. 14.

• Completely unwind the high pressure hose (25).

• Open the water supply tap (if connected to the drinking water mains it is mandatory to use a back-flow

preventer (not supplied). Operation H in Fig. 14. To use this device refer to the relevant instruction manual),

making sure there are no drips. Alternatively, put a suction hose in a tank (K Steel 7.15 and K Steel 10.21

excluded, as they are fitted with a thermostatic valve and must work only with mains water).

• Make sure the master switch (1) is on "0" position and insert the plug. Operation B in Fig. 12.

• Move the master switch (1) to "1" position: the indicator light (31) lights up on the control panel.

• Press the spray gun lever (15) and wait for a continuous jet of water to come through which means

the pump is priming correctly.