Optional Accessories; Operation - Comet K Steel S Bedienungs- Und Wartungsanleitung

- instruction manual - operation and maintenance;
- declaration of conformity;
- booklet giving the assistance centres;
- warranty certificate;
- ejector kit;
- the handle fixing kit: screws, washers, knobs;
- nozzle cleaning pin.
If any problems arise please contact your dealer or an authorised assistance centre.
You can add the following range of accessories to the standard ones supplied with your high pressure
cleaner:
• sandblasting lance: designed to smooth surfaces, removing rust, paint, encrustations, etc.;
• drain cleaning kit: designed to unclog pipes and ducts;
• different types of lances and nozzles;
• rotating brush: designed for cleaning fragile surfaces;
• rotating nozzle: designed for removing stubborn dirt;
• foam lance: designed for a more efficient distribution of the detergent;
• hose reel: to increase working range thanks to a longer hose and practical housing for it.
Please contact your dealer to know more about the complete accessory range.
INSTALLATION - ASSEMBLING THE ACCESSORIES
• Fix the handle (2) to the frame using the kit supplied: screws (30), washers (31) and knobs (29) (using
the Allen key supplied). Operation E in Fig. 1.
• Unwind the high pressure hose (25) and screw the end (without the quickfit coupling) onto the spray
gun (17) thread and tighten well with two 22 mm fixed jaw spanners (not supplied). Operation D in
Fig. 6.
• Connect the quickfit coupling (26) to the water outlet fitting (12), screw down and tighten the ring nut
by hand. Operation E in Fig. 6.
• Fit the filter (18) in the water inlet connection (13). operation D in fig. 2.
• Follow the instructions given in the "Routine maintenance" and "Special Maintenance" paragraphs.
• Take the high pressure cleaner to the place of work using the handle (2).
• Completely unwind the high pressure hose (25).
• Fasten a supply hose with inner diameter 15 mm/0.59 inches to the water inlet quick-fit connection,
using an ordinary gardening quick-fit connection. Operation I in Fig. 7.
• Open the water supply tap (if connected to the drinking water mains it is mandatory to use a back-flow
preventer (not supplied). Operation H in Fig. 7. To use this device refer to the relevant instruction manual),
making sure there are no drips. Alternatively, put a suction hose in a tank.
• Make sure the master switch (1) is on "0" position and insert the plug. Operation B in Fig. 5.
• Move the master switch (1) to position "1".
• Press the spray gun lever (15) and wait for a continuous jet of water to come through which means
the pump is priming correctly.
• Move the master switch (1) to "0" position and close the water supply tap.
• Press the spray gun lever (15) to discharge any residual pressure.
• Connect the lance hose (22) to the spray gun (17), tightening it firmly. Operation C in Fig. 6.
• Make sure the nozzle holder head (15) is not in the detergent dispensing position (refer to
WITH DETERGENT"
22

OPTIONAL ACCESSORIES

OPERATION – PRELIMINARY ACTIVITIES
STANDARD OPERATION (HIGH PRESSURE)
paragraph).

"OPERATION