Optional Accessories - Comet K Steel S Bedienungs- Und Wartungsanleitung

- declaration of conformity;
- booklet giving the assistance centres;
- warranty certificate;
- handle fixing kit: screws, washers, knobs (TS, Eco) or nuts (S);
- suction kit with: fitting, gasket/filter and clamp (S); fitting, gasket and clamp (all the other models);
- detergent suction hose kit including filter and clamp (S, TS);
- nozzle cleaning pin.
If any problems arise please contact your dealer or an authorised assistance centre.
You can add the following range of accessories to the standard ones supplied with your high pressure
cleaner:
• sandblasting lance: designed to smooth surfaces, removing rust, paint, encrustations, etc.;
• drain cleaning kit: designed to unclog pipes and ducts;
• different types of lances and nozzles;
• rotating brush: designed for cleaning fragile surfaces;
• rotating nozzle: designed for removing stubborn dirt;
• foam lance: designed for a more efficient distribution of the detergent;
• hose reel: to increase working range thanks to a longer hose and practical housing for it.
Please contact your dealer to know more about the complete accessory range.
INSTALLATION - ASSEMBLING THE ACCESSORIES
• Contact a Specialized Technician to connect a suitable power cable to the plug (46) (Xtreme).
CAUTION
• It is the Specialized Technician's responsibility to ensure that the power cable is at least 5 m/17 ft
long with a minimum section of 10 mm
sheath (code 60245 IEC 66 or higher).
• If an extension is used, bear in mind that it must have exactly the same characteristics as the power
cable and must be no longer than 5 m/16 ft.
• Fix the handle (2) using the kit supplied: screws (9), washers (10) and knobs (11) (TS, Eco); screws (9),
washers (10) and nuts (12) (S) (in this case use a 13 mm fixed jaw spanner, not supplied). Operation B
in Fig. 1 and 3.
• Unwind the high pressure hose (35) and screw the end (without the quickfit coupling) onto the spray
gun (24) or (54) or (55) thread and tighten well with two 22 mm fixed jaw spanners (not supplied)
(S, TS, Eco). Operation E in Fig. 7.
• Connect the quickfit coupling (36) to the water outlet fitting (16), screw down and tighten the ring nut
by hand (S, TS, Eco). Operation F in Fig. 7.
• Insert the gasket/filter (64) (S) or the gasket (26) (all the other models) in the water inlet fitting (17) and
screw the water inlet hose-end fitting (25) on to it. Operation C in Fig. 7.
• Clamp (37) the free end of the detergent suction hose (38) to the detergent suction fitting (15) (S, TS).
Operation D in Fig. 7.
OPERATION – PRELIMINARY ACTIVITIES (S, TS, ECO, 1001-1251-1501)
• Follow the instructions given in the "Routine maintenance" and "Special Maintenance" paragraphs.
• Take the high pressure cleaner to the place of work using the handle (2).
• Engage the parking brake (20).
28

OPTIONAL ACCESSORIES

2
and that it is the flexible type in a heavy duty polychloroprene