Optional Accessories; Preliminary Operations - Comet KP-Serie Bedienungs- Und Wartungsanleitung

Heiswasser-hochdruckreiniger

Inhaltsverzeichnis

Verfügbare Sprachen

The following range of accessories can be added to the standard equipment supplied with the high

pressure cleaner:

• hose reel;

• cleaner gun with pressure regulator;

• ion acceleration limescale remover;

• sandblasting lance: designed for sanding surfaces, removing rust, paint and lime scale deposits, etc;

• pipe flushing probe: designed for unblocking pipes and ducts;

• rotating nozzle lance: designed for the removal of stubborn dirt;

• foaming lance: designed for a more efficient distribution of detergent;

• various types of lances and nozzles;

• back-flow preventer: designed to comply with the standards relative to connecting to the drinking water

mains;

• rotating brush: conceived for delicately and effectively cleaning large surfaces such as the bodywork of

vehicles;

• exhausted fumes conveyor.

• Connect the quick fit connector (31) on the hose (30) to the water outlet connector (16) and secure the

ring nut tightly by hand. Step B in Fig. 8.

• Screw the connector (37) on the high pressure hose onto the thread of the cleaner gun (24) or (40) and

tighten it using two 22 mm spanners (not supplied). Step A in Fig. 8.

• Insert the filter (18) in the connector (17) and the seal (26) in the hose support (25); screw the hose

support (25) onto the connector (17). Step C in Fig. 8.

• Unscrew the screw (19) using an allen wrench (6 mm / 0,23" ) not supplied, move the handle as in Step

F in Fig. 1, then tighten the screw again to keep the handle in place.

• Use the handles (2) to move the high pressure cleaner to the area where it is to be used.

• Engage the brake (34) on the swivel wheel (33).

• Unwind the high pressure hose completely (30).

• Using the collar clamp (39), secure a supply pipe to the water inlet hose support (25) that has an inside

diameter of 19 mm/0.75 in. Step C in Fig. 8.

• Connect the water supply hose to a tap.

• Open the water tap (if connecting to the mains water supply, you must use a backflow hydraulic device:

please refer to the relative instruction manual), making sure that there is no dripping (or place the suction

pipe in a draft tank).

• Check the detergent adjustment knob (29) is closed properly.

• Check the master switch (1) is set at "0" and connect the plug. Step D in Fig. 8.

• Turn the master switch (1) to "I".

NOTE (three-phase models only): if the warning light (36) is flashing it means you need to contact a

Specialized Technician to reverse the connection of two phases of the high pressure water cleaner plug

or of the socket it is connected to.

• Press the cleaner gun lever (22) and wait for an even stream of water to be produced.

• Turn the master switch (1) to "0" and connect the lance pipe (21) to the cleaner gun (24) or (40), securing

it firmly. Step E in Fig. 8.