Optional Accessories - Comet FDX Xtreme serie Bedienungs- Und Wartungsanleitung

Inhaltsverzeichnis

Verfügbare Sprachen

You can add the following range of accessories to the standard ones supplied with your high pressure

cleaner:

• sandblasting lance: designed to smooth surfaces, removing rust, paint, encrustations, etc.;

• drain cleaning kit: designed to unclog pipes and ducts;

• different types of lances and nozzles;

• rotating brush: designed for cleaning fragile surfaces;

• rotating nozzle: designed for removing stubborn dirt;

• foam lance: designed for a more efficient distribution of the detergent.

• the FDX Xtreme / XL high pressure hose (59) has two quickfit couplings (34) so you need

no spanners to screw it onto the spray gun – simply screw right down and tighten the ring

nut by hand: connect the quickfit coupling (34) to the sleeve-free end (60) of the spray gun

• Connect the quickfit coupling (34) to the water outlet fitting (15), screw down and tighten the ring nut

by hand. Operation C in Fig. 5.

• Insert the gasket (49) in the water inlet fitting (16) and screw the water inlet hose-end fitting (11) on

to it. Operation D in Fig. 5.

• Fill the engine crankcase with oil, following the instructions given in the relevant operating and

maintenance manual (this is not to be done on machines with Diesel engines as they are filled with

oil in the factory).

• Do the preliminary activities described in the operating and maintenance manual of the engine

mounted on the high pressure cleaner. In particular remember to fill with fuel and check the level of

engine oil.

NOTE: the FDX XTREME / XL model has a capacious tank (28) integrated in the high pressure cleaner

frame.

• When the engine is off and the machine is completely cold, check the level of pump oil by way of the

level indicator (38). Also check the gearbox oil level by way of the level indicator (44) on those models

thus equipped.

When topping up is needed please refer to the lubricant types given in the

TECHNICAL DATA"

• Check if the water inlet filter (23) is clean.

• Take the high pressure cleaner to the place of work using the handle (4).

• Engage the parking brake (41).

• Unwind the high pressure hose completely (59).

• Exploiting the clamp (12) supplied, fix a supply hose with an inside diameter of 30 mm/1.2 In to the

water inlet hose-end fitting (11). Operation G in Fig. 5.

• Start the engine, referring to the relevant operating and maintenance manual.

• Open the water supply tap (if connected to the drinking water mains it is mandatory to use a back-flow

preventer: to use this device refer to the relevant instruction manual), making sure there are no drips.

Alternatively, put a suction hose in a tank.

• Press the spray gun lever (33) and wait for a continuous jet of water to come through which means

the pump is priming correctly.

• Stop the engine, referring to the relevant operating and maintenance manual, and close the water

supply tap, if any.

• Press the spray gun lever (33) to discharge all residual pressure.