Identification Of Components; Safety Devices - Comet K Steel Bedienungs- Und Wartungsanleitung

Refer to Figures 4 to 9:
1. ON/OFF Master switch
2. Handle
3. Lance support
4. Warning plates. Inform on residual risks and
PPE to be used
5. Identification plate. Indicates the serial number,
guaranteed sound power value (in compliance
with Directive 2000/14/EC) and main technical
characteristics
6. Power cable
7. Delivery hose/power cable support
8. Pressure adjustment knob
9. Pressure indicator
10. Oil plug with vent and dipstick
11. Detergent suction fitting
12. Water outlet fitting
13. Water inlet fitting
14. Water inlet filter (K Steel XL)
15. Spray gun lever
16. Spray gun lever safety stop
17. Spray gun
18. Water inlet hose-end fitting
19. Gasket for water inlet hose-end fitting
20. Water inlet filter cartridge
• Automatic reset thermal protector.
Device that stops the operation of the high pressure washer if the electric motor overheats.
In this case, proceed as follows:
- move the master switch (1) to "0" position and remove the plug from the power socket;
- press the spray gun lever (15), so as to release any residual pressure;
- wait 10÷15 minutes for the high pressure cleaner to cool down;
- make sure the instructions for connection to the power supply are complied with (refer to the
Instruction manual – Safety precautions), with special reference to the extension used;
- fit the plug back in the socket and repeat the start procedure described in the paragraph "Operation".
• Pressure unloader/regulation valve.
Valve, suitably calibrated by the Manufacturer, for regulating work pressure by means of the knob (8)
and that allows the pumped fluid to return to pump suction thus preventing the onset of dangerous
pressures, when closing the spray gun or when trying to set a pressure that is above the maximum
permitted values.
• Spray gun lever lock device.
Safety stop (16) for locking the spray gun (17) lever (15) in the closed position so it cannot be started
accidentally (Fig. 7, position S).
Make sure the following are inside the pack of the product you have purchased:

IDENTIFICATION OF COMPONENTS

SAFETY DEVICES

STANDARD FITTING
21. Water inlet filter cap
22. Lance hose
23. Nozzle holder head
24. Nozzle cleaning pin
25. High pressure hose
26. High pressure hose quickfit coupling
27. Detergent suction hose clamp
28. Detergent suction hose
29. Detergent suction filter
30. Thermostatic valve (only K Steel 7.15 and K Steel
10.21)
31. Mains voltage LED
32. Routine maintenance alarm indicator light
33. Oil sight indicator
34. Hose clamp
35. Water inlet filter cartridge (K Steel)
36. Water inlet bent hose barb (K Steel XL)
37. Detergent tank
38. Ejector kit
39. Double barrel lance knob
40. Foot
EN
29