Optional Accessories - Comet K Xtreme 700 bar Bedienungs- Und Wartungsanleitung

WARNING
• When the emergency push button (25) is pressed, lever (15) on the high pressure cleaner must be pressed
immediately after to discharge any residual pressure.
• Relief valve.
Maximum pressure valve (26), discharges any excess pressure in the case of a malfunction in the pressure
regulating system.
Make sure the following are inside the pack of the product you have purchased:
• high pressure cleaner;
• high pressure delivery hose;
• spray gun;
• bag of accessories with:
- instruction manual - safety precautions;
- instruction manual - operation and maintenance;
- declaration of conformity;
- suction kit with: fitting, gasket and clamp;
- nozzle cleaning pin.
If any problems arise please contact your dealer or an authorised assistance centre.
You can add the following range of accessories to the standard ones supplied with your high pressure
cleaner:
• sandblasting lance: designed to smooth surfaces, removing rust, paint, encrustations, etc.;
• drain cleaning kit: designed to unclog pipes and ducts;
• different types of lances and nozzles;
• rotating nozzle: designed for removing stubborn dirt;
Please contact your dealer to know more about the complete accessory range.
INSTALLATION - ASSEMBLING THE ACCESSORIES
- Unwind the high-pressure hose (23) and insert the guard (42) by the fitting (22). Operation F of Fig. 11.
Screw the fitting (22) to the thread of the spray gun (17) and tighten well using two fixed wrenches
(not supplied). Operation E of Fig. 10.
- Fasten the strap of the guard (42) on the handle of the spray gun. Operation G of Fig. 11.
- Screw the fitting (24) of the high-pressure hose (23) to the thread of the water outlet fitting (10) and
tighten well using two fixed wrenches (not supplied). Operation C of Fig. 10.
- Attach the two rings of the safety sleeve (37) of the high-pressure hose (23) to the shackle hooks located
on the frame. Operation D of Fig. 10
• Follow the instructions given in the "Routine maintenance" and "Special Maintenance" paragraphs.
• Take the high pressure cleaner to the place of work using the handle (2).
• Engage the parking brake (13).
• Using the clamp (38) supplied, fix a supply hose with an inside diameter of 30 mm in to the water inlet
hose-end fitting (18). Operation B in Fig. 9.
STANDARD FITTING

OPTIONAL ACCESSORIES

OPERATION – PRELIMINARY ACTIVITIES
EN
25