Nicd/Nimh - Discharge Mode; Nicd/Nimh - Re-Peak Mode - HITEC X1 Pro Bedienungsanleitung

Professional Balance Charger, Discharger
8.3. NiCd/NiMH - Auto Charge Mode
Once charging has commenced, the
NiMH 1.6A 5.96V
AUT 003:43 00090
charger will display the following
real-time information: battery type, charging current, battery
voltage, charging time and charged capactiy.

8.4. NiCd/NiMH - Discharge Mode

Before you begin discharging your battery,
make sure you have read and understand all
of the warnings and safety information.
Select the correct battery type by following the instruction
on page 38. Once you have set the correct battery type, toggle
up or down until you see the "
screen.
Toggle right once and the amp rate value will begin
fl ashing. Toggle up or down
the desired rate. Follow the instructions provided with your
battery when setting the amp rate.
Toggle right
NiMH DISCHARGE
0.1A CUT: 1.0V
the fi nal voltage value will begin
fl ashing.

8.5. NiCd/NiMH - Re-Peak Mode

In Re-Peak Charge mode, the charger can automatically peak
charge the battery 1-3 times consecutively. This is good for
confi rming that the battery is fully charged, and for checking
how well the battery receives fast charges. A fi ve minute
cool-off delay occurs after each re-peak charge.
Before you begin discharging your battery,
make sure you have read and understand all
of the warnings and safety information.
Select the correct battery type by
NiMH RE-PEAK
1
following the instructions on
page 38. Once you have set the correct battery type, toggle
up or down until you see the "
screen.
Toggle right once and the # of re-peak cycles will begin
fl ashing. Toggle up or down
NiMH DISCHARGE "
to adjust the value to
once again and
NiMH RE-PEAK "
to change the number
Once the battery is fully charged the screen will read
" " and the charger will emit a chiming
END:FINISHED
sound. Toggle left once to stop charging. You may toggle
left at any time during the charging process to stop charging.
Toggle up or down to adjust the value to the desired
rate. The discharge current ranges from 0.1 to 8.0 A and
the fi nal voltage ranges from 0.1 to 25.2 V.
Toggle and hold the joystick to the right
seconds to begin discharging.
Once disharging has commenced,
NiMH 1.0A 5.96V
DSC 001:43 00030
the charger will display the
following real-time information: battery type, discharging
current, battery voltage, discharging time and discharged
capactiy.
Once discharging is complete the screen will read
" [DISCHARGE FINISHED]
emit a chiming sound. Toggle left
You may toggle left at any time during the discharging
process to stop discharging.
of re-peak cycles you want the X1 Pro to execute. The X1
Pro can re-peak charge the battery a maximum of 3 times
consecutively.
The X1 Pro will use the amperage value entered in Charge
Mode for this operation. Toggle and hold the joystick to the
right for three seconds to begin charging.
Once charging has commenced,
NiMH 1.6A 5.96V
RPC 002:51 00090
the charger will display the
following real-time information: battery type, charging
current, battery voltage, charging time and charged
capactiy.
Once charging is complete the screen will read "
" and the charger will emit a chiming sound.
FINISHED
Toggle left once to stop charging. You may toggle left
at any time during the charging process to stop charging.
for three
" and the charger will
once to stop discharging.
END:-
39