Lithium - Fast Charge Mode - HITEC X1 Pro Bedienungsanleitung

Professional Balance Charger, Discharger

7.4. Lithium - Fast Charge Mode

Before you begin charging your battery, make
sure you have read and understand all of the
warnings and safety information.
See page 31 for the appropriate charging connections
setup for this operation.
First, select the correct battery
LiPo FAST CHG
8.1A 22.2V(6S)
type by following the instructions
on page 33. Once you have set the correct battery type,
toggle up or down until you see the "
CHG " screen.
Toggle right
LiPo FAST CHG
0.8A 22.2V(6S)
rate value will begin fl ashing.
Toggle up or down to adjust the value to the desired
rate. Follow the instructions provided with your battery
when setting the amp rate.
Toggle right
LiPo FAST CHG
0.8A 11.1V(3S)
cell count value will begin fl ashing.
Toggle up or down to adjust the cell count. This will
automatically change the voltage value to the correct
setting for the selected cell count. The cell count should
exactly match the battery label.
Toggle and hold the joystick to the right
and you will see " BATTERY CHECK WAIT...
by the " CONFIRM/CANCEL
This screen displays the number
R:3SER S:3SER
CONFIRM(ENTER)
of cells you set up as "
the number of cells detected by the processor as "
LiPo FAST
once and the amp
again and the
for three seconds
"followed
" screen.
" and
R
S ".
In the fast Charge Mode, lithium batteries can
be charged without the use of a balance adaptor.
A balance adapter can be used, but it is not
required. Balance charge mode is recommended
for any battery with a balance lead.
If both numbers are identical, you may toggle right
to confi rm and begin charging. If the cell count does not
match, toggle left once to return to the previous screen
and carefully check the number of cells of the battery pack
before proceeding.
Once charging has commenced,
Li3s 1.2A 12.69V
FAS 022:43 00682
the charger will display the
following real-time information: battery type/cell count,
charging current, battery voltage, charging time and
charged capactiy.
During charging, the battery should be placed
inside a fi reproof/retardant bag and on a fi re
proof surface, away from other combustible
objects.
If you are using a balance adaptor,
4.09 4.09V 4.09V
0.00 0.00V 0.00V
during charging you may toggle
up once to view the voltage of each individual cell.
Once the battery is fully charged the screen will read
" [END:FINISH] " and the charger will emit a chiming
sound. Toggle left once to stop charging. You may toggle
left at any time during the charging process to stop
charging.
once
35